Water in a cold fireplace can arrive through several paths. Keep the appliance unused and arrange an inspection of the system and adjacent water-shedding details.
Updated September 10, 2026
Your home in Green Bay.
About 75% of occupied homes in Green Bay heat primarily with utility gas. Many chimneys in Green Bay therefore vent a gas furnace, boiler, or water heater rather than a wood fire, and those flues still need inspection for liner condition, moisture, and blockage. About 0.2% of occupied homes in Green Bay use wood as their primary heating fuel. Most fireplaces in Green Bay see occasional use, and even occasional use calls for an inspection before the heating season. The nearest NOAA climate normals station (Green Bay Botanical, about 6 miles from the Green Bay city center) averages 7,791 heating degree days per year. That is a long heating season in which venting runs for months and freeze-thaw cycles work on exposed masonry, so check exposed brick and the crown after winter from a safe position.
What you can observe safely
- Record when water appeared.
- Keep people away from wet electrical components.
What to avoid
- Do not climb onto the roof or enter the chimney.
- Do not alter gas components, venting, or safety controls.
- Do not use a test fire to diagnose the problem.
Possible causes to assess
- Chimney termination condition
- Flashing or enclosure leak
- Other moisture sources
A symptom cannot establish the cause remotely. An assessment of the complete system helps determine the appropriate repair.
Chimney repair in Green BayA few common questions
Can this be diagnosed from a photo?
A photo can document a symptom and help prepare a visit. It cannot confirm concealed conditions or establish that a chimney or fuel-burning appliance is safe.