Chimney & Fireplace Services in Aurora.
Chimney and fireplace care for Aurora homes. The median home here was built in 1985, and the nearest weather station averages 5,934 heating degree days a year.
How old is the housing an Aurora chimney belongs to?
Half of Aurora's housing units were built in 1985 or earlier, which puts the median Aurora home at about 38 years old by the 2023 end of the estimates that figure comes from.
Among the four Colorado cities with a page here the medians run from 1974 in Denver to 1992 in Fort Collins, so Aurora sits 11 years on the newer side of the oldest.
Around 1985 masonry chimneys and factory-built fireplaces were both common, so which of the two is in the house decides the scope of the visit and which parts fit it.
Is an Aurora chimney usually on a detached house?
More often than not: 53.3% of Aurora housing units are single-family detached, with about 46.7% counted in some other structure type.
Taken against the 150,242 housing units the Census counts in Aurora, 53.3% works out at roughly 80,100 detached homes; the same table files the rest under some other structure type, from an attached house to an apartment building or a mobile home.
Most Aurora chimneys serve one household and can be looked at from the ground and the roof without another owner's permission; the 46.7% outside the detached category still raises the access question.
Source: U.S. Census Bureau, ACS 5-Year Estimates 2019-2023, table B25035, retrieved 2026-09-15 ↗Source: U.S. Census Bureau, ACS 5-Year Estimates 2019-2023, table B25024, retrieved 2026-09-15 ↗Source: U.S. Census Bureau, ACS 5-Year Estimates 2019-2023, table B25001, retrieved 2026-09-15 ↗
What the data says about Aurora homes.
Source: U.S. Census Bureau, ACS 5-Year Estimates 2019-2023, retrieved 2026-09-15. Source: NOAA National Centers for Environmental Information, U.S. Climate Normals 1991-2020 (annual/seasonal), retrieved 2026-09-15.
- Population
- 390,201
- Housing units
- 150,242
- Median year built
- 1985
- Single-family detached homes
- 53.3%
- Owner-occupied homes
- 63.3%
- Heat with utility gas
- 62.6%
- Heat with wood
- 0.1%
- Heating degree days per year
- 5,934
Our services in Aurora.
Choose the care your home needs.
Our team will confirm the scope for your system.
A season ahead. A step prepared.
What does an Aurora chimney usually vent?
62.6% of occupied Aurora homes heat primarily with utility gas, and 0.1% heat primarily with wood.
Those are heating shares, not a count of fireplaces, but at 62.6% an Aurora flue is more likely to be carrying the exhaust of a furnace, boiler or water heater than the smoke of a wood fire, and that flue needs checking for blockage, moisture and liner condition rather than creosote.
A wood share of 0.1% means almost no Aurora home depends on wood for heat, so most fires here are occasional — which still leaves deposits, and still leaves the flue idle long enough for nests and debris to collect.
How hard does an Aurora chimney work in winter?
The NOAA climate-normals station nearest Aurora averages 5,934 heating degree days a year.
Across the four Colorado cities with a page here the stations run from 5,918 near Fort Collins to 6,292 near Colorado Springs, putting Aurora under 1% above the milder end.
5,934 degree days is a heating season long enough that a flue in Aurora is working steadily for a good part of the year; book the inspection before it starts rather than during it.
Degree days measure heating demand, not freeze-thaw cycles: 5,934 says how long the flue is in use, not how much the masonry around it moves.
Source: U.S. Census Bureau, ACS 5-Year Estimates 2019-2023, table B25040, retrieved 2026-09-15 ↗Source: NOAA National Centers for Environmental Information, U.S. Climate Normals 1991-2020 (annual/seasonal), retrieved 2026-09-15 ↗
Care for your fireplace — and your home.
- Checking the liner against the connected appliance
- Recording cold drafts and smoke spillage before a visit
- Ground-level notes on crown cracks and flaking brick
More service cities in Colorado.
Choose your city for services, common concerns, and a request tailored to your home.
Understand the work.
Plan the investment.
Before we visit.
Which service should I request?
If the cause is unclear, start with an inspection and describe what you’ve noticed. Water, cracking, smoke, and an appliance that will not light can involve different parts of the system.
What should I have ready?
Have any previous inspection reports and accessible appliance information ready. Note when the concern appears. Do not climb onto the roof or operate an appliance that shows unsafe symptoms.
What if I smell gas or a carbon monoxide alarm sounds?
Leave the building and contact emergency services or your gas utility from a safe location. Do not use the estimate form for emergency assistance.
Let’s take care
of your home.
Your city and state are already selected.
Tell our team a little more about the work.
Loading the estimate form…