Thoughtful care. From chimney to hearth.
COLORADO CHIMNEY PROS

Chimney liner repair in Colorado Springs, CO

We repair and replace chimney flue liners, and explain which option suits the appliance connected to that flue. In Colorado Springs that means housing with a median build year of 1986, in a place the nearest NOAA station puts at 6,292 heating degree days a year.

Call Colorado Chimney Pros (888) 481-4424
Updated September 10, 2026
Two harnessed technicians feeding a stainless steel liner into a red brick chimney with a concrete crown from a dry roof; illustrative image
Illustrative service image — not a documented company job
CHIMNEY / FIREPLACE / HOMEColorado
The short answer

A liner proposal should identify the existing system, show the defect, and explain why the proposed repair or replacement fits the connected appliance. Avoid choosing a liner from price or diameter alone.

Colorado Springs homes and their flues

Public figures for Colorado Springs as a whole. They describe local housing and heating, not your home, so the visit still starts with your own chimney.

Median year built
1986
Half of Colorado Springs's housing units were built in 1986 or earlier, so the median Colorado Springs chimney had about 37 years behind it by the 2023 end of the estimates. Fort Collins, also in Colorado, records 1992, 6 years newer. A liner fitted around 1986 was sized for the appliance of 1986; what matters now is whether it suits the one connected today.
Source: U.S. Census Bureau, ACS 5-Year Estimates 2019-2023, table B25035, retrieved 2026-09-15
Homes heated mainly with utility gas
69.8%
69.8% of occupied Colorado Springs homes heat primarily with utility gas, so about 30.2% run on oil, electricity, propane or something else. Wood is the primary heat in 0.4% of them. A liner has to suit the appliance it vents, and in Colorado Springs that is a gas appliance about 69.8% of the time.
Source: U.S. Census Bureau, ACS 5-Year Estimates 2019-2023, table B25040, retrieved 2026-09-15
Homes heated mainly with wood
0.4%
0.4% of occupied Colorado Springs homes heat primarily with wood, against 69.8% on utility gas — a gap of 69.4 percentage points. Fort Collins, also in Colorado, records the same figure; across the 4 Colorado cities on this site it runs from under 0.1% to 0.4%. At 0.4%, almost no Colorado Springs home depends on wood for heat, so most fires here are occasional — which still leaves deposits, and leaves the flue idle long enough for debris and nests to collect.
Source: U.S. Census Bureau, ACS 5-Year Estimates 2019-2023, table B25040, retrieved 2026-09-15
Heating degree days a year
6,292
The NOAA climate-normals station nearest Colorado Springs averages 6,292 heating degree days a year. Fort Collins, also in Colorado, records 5,918, about 6% less. Degree days measure heating demand, not freeze-thaw cycles, so 6,292 says roughly how long a Colorado Springs flue is in use across a year, not how much the masonry around it moves. Book before the season rather than during it.
Source: NOAA National Centers for Environmental Information, U.S. Climate Normals 1991-2020 (annual/seasonal), retrieved 2026-09-15
The work

What liner work covers

Included

  • Confirming which flue has the problem and which appliance it serves
  • Locating the defect inside the flue, with a camera where needed
  • Explaining whether a repair or a replacement suits that liner
  • The agreed repair or relining, sized for the connected appliance
Fireplace insert in a grey shiplap wall
Your estimate

Prices and estimates

Prices are not listed here: an estimate depends on what the visit finds.

The visit

Before and after the visit

Sections of stainless steel flue liner, clamps and a top plate arranged on a canvas tarp; illustrative image
Illustrative service image — not a documented company job

Before the visit

  • If a report says to stop using the appliance on that flue, keep it off until the repair.
  • Share the earlier report and any photos that show the defect.
  • Find the appliance manual or a model label you can see without opening panels.

Afterwards, keep

  • The flue and appliance the work applies to
  • The liner material and size
  • Any limits on use until other work is done

The visit step by step, what moves the estimate, what this service leaves out, and more common questions:

Chimney liner repair in Colorado
Questions

Questions about liners

General answers. The findings at your home come first.

Should I stop using the appliance on that flue?

If a report or the findings say the liner is damaged, keep the appliance on that flue off until it is repaired: a damaged liner can let heat or combustion gases reach parts of the house they should not. If a carbon monoxide alarm sounds, leave and call 911.Source: U.S. Consumer Product Safety Commission, Carbon Monoxide Fact Sheet

Colorado Chimney Pros

Chimney liner repair elsewhere in Colorado

Aurora, about 58 miles from Colorado Springs, Denver, about 62 miles from Colorado Springs, and Fort Collins, about 117 miles from Colorado Springs. Whether we can schedule work at your address is confirmed after we review your request.

Colorado Chimney Pros

Request an estimate

Chimney liner repair in Colorado Springs, CO is already selected in the form. Tell us what you have noticed and choose a preferred time.

A request does not confirm an appointment.

Loading the estimate form…